INSTALLATION PROCEDURE FOR LAVA 16550 UART
SERIAL CARDS IN NT3.51

1) Create a DOS boot diskette on a non-NT system
(DOS, WIN9x, or Win3.11) using the following command:

  format a: /s

2) Copy lavaconf.exe (our Lava PCI card detection routine)
to that installation diskette.

3) Insert the Lava PCI 16550 PCI card into an available PCI slot.

4) Boot to the DOS boot diskette.

5) Run lavaconf.exe from that diskette.

6) Record what Lavaconf reports.

7) Restart the computer and boot to NT3.51

8) Go to Control Panel and Click Ports.

9) Click Add and then click the Properties for the port that was added.

10) Go to Settings and then Advanced.

11) Configure the IO address and IRQ to what you recorded in step 6.
(NOTE: the IO address will not be a choice in the list. You must type
over what is in the list.)

12) Repeat steps 9-11 for all the Lava Serial ports you are adding.

13) Reboot after all the ports have been added.